Skip to page content
USDA Forest Service
  
Treesearch

Research & Development Treesearch

 
Treesearch Home
About Treesearch
Contact Us
Research & Development
Forest Products Lab
International Institute of Tropical Forestry
Northern
Pacific Northwest
Pacific Southwest
Rocky Mountain
Southern Research Station
Help
 

Science.gov - We Participate


USA.gov  Government Made Easy


Global Forest Information Service

US Forest Service
P.O. Box 96090
Washington, D.C.
20090-6090

(202) 205-8333

You are here: Home / Search / Publication Information
Bookmark and Share

Publication Information

View PDF (1.1 MB bytes)

Title: Strength and stiffness of small glued-laminated beams with different qualities of tension laminations

Author: Marx, Catherine M.; Moody, Russell C.;

Date: 1981

Source: Res. Pap. FPL-RP-381. Madison, WI: U.S. Department of Agriculture, Forest Service, Forest Products Laboratory. 48 pages

Publication Series: Research Paper (RP)

Description: A total of 180 small Douglas Fir–Larch (DF-L) or Southern Pine (SP) glued-laminated beams were evaluated to determine the tension lamination quality necessary to obtain desired design stresses. The test beams had either the regular laminating grades of L1 DF-L/No. 1D SP or the special 302-24 laminating grade as tension laminations. Because an initial set of SP beams did not provide valid strength data due to a high frequency of finger-joint failures, a second set of SP test beams was manufactured. Although the initial set of SP beams could not be used to answer the objectives of this study, it did indicate that current strength requirements for daily fingerjoint quality-control bending tests need to be increased. The 60 DF-L beams and the 60 beams for the second set of SP beams show that specially graded tension laminations are necessary even for 4-lamination beams. A tension lamination grade between the regular laminating grades of L1 or No 1D and the special laminating grade called 302-24 may be adequate on a 4-lamination beam to obtain a 2,400 lb/in.2 design stress. The 8- and 10-lamination beams, however, appeared to require a 302-24 grade tension lamination to obtain that design stress. The strength of test beams with L1 or No. 1D grade tension laminations was about 15 percent less than the strength of test beams with 302-24 grade tension laminations. This suggests a 2,000 Ib/in.2 design stress for the test beam combinations with L1 or No. 1D grade tension laminations. The data will provide guidelines to industry committees in recommending design stresses and specifications for glulam beams.

Keywords: Glulam, glued laminated beams, strength, stiffness, tension laminations

Publication Notes:

  • We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
  • This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.

XML: View XML

Citation:


Marx, Catherine M.; Moody, Russell C. 1981. Strength and stiffness of small glued-laminated beams with different qualities of tension laminations. Res. Pap. FPL-RP-381. Madison, WI: U.S. Department of Agriculture, Forest Service, Forest Products Laboratory. 48 pages

 


 [ Get Acrobat ]  Get the latest version of the Adobe Acrobat reader or Acrobat Reader for Windows with Search and Accessibility

USDA logo which links to the department's national site. Forest Service logo which links to the agency's national site.