Skip to page content
USDA Forest Service
  
Treesearch

Research & Development Treesearch

 
Treesearch Home
About Treesearch
Contact Us
Research & Development
Forest Products Lab
International Institute of Tropical Forestry
Northern
Pacific Northwest
Pacific Southwest
Rocky Mountain
Southern Research Station
Help
 

Science.gov - We Participate


USA.gov  Government Made Easy


Global Forest Information Service

US Forest Service
P.O. Box 96090
Washington, D.C.
20090-6090

(202) 205-8333

You are here: Home / Search / Publication Information
Bookmark and Share

Publication Information

View PDF (2.31 MB bytes)

Title: Slash pine rootwood in flakeboard

Author: Howard, Elaine T.;

Date: 1974

Source: Forest Products Journal, Vol. 24(6): 29-35

Publication Series: Miscellaneous Publication

Description: Flakes 3 inches along the grain, 3/8-inch wide, and 0.02 inch thick were machined from the taproots (with 6-inch-high stump) and second logs of eight 31-year old slash pines. Specific gravity (O.D. weght, green volume) of stems averages 0.52; rootwood averaged 0.43 and decreased sharply with depth below ground. Forty-four-lb./cu. ft. structural-type particleboards were prepared with random orientation of flakes and 5 percent phenol-formaldehyde solids. Stemwood boards were stiffer (737,000 psi MOE) than rootwood boards (643,000 psi MOE), but bending strength was lower (4,8000 psi MOr) for stemboards than for rootwoods (5,500 psi MOR). MOE/MOR ratio was 155 for stemboards and 118 for rootboards. The two types of boards did not differ in nail-withdrawal resistance (96 and 97 lb.). Internal bond of rootboards (114 psi) was almost double that of stemboards (60 psi); the difference was associated in part with the greater densification of rootwood (x 1.66) as compared with stemwood (x 1.36). Root flakes were more compared with stemwood (x 1.36). Root flakes were more comformable but had higher proportions of grain deviation and damaged surfaces. Rootboards had greater dimensional movement in both planes. Grater soaked moisture content, greater thickness springback, and greater recovery from linear swell. Interrelations of board properties differed for the two materials. Differences appeared to be primarily due to anatomical characteristics, lower inherent strength of rootwood, degree of densification, and machinability.

Publication Notes:

  • We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
  • This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
  • You may send email to pubrequest@fs.fed.us to request a hard copy of this publication. (Please specify exactly which publication you are requesting and your mailing address.)

XML: View XML

Citation:


Howard, Elaine T. 1974. Slash pine rootwood in flakeboard. Forest Products Journal, Vol. 24(6): 29-35

 


 [ Get Acrobat ]  Get the latest version of the Adobe Acrobat reader or Acrobat Reader for Windows with Search and Accessibility

USDA logo which links to the department's national site. Forest Service logo which links to the agency's national site.