Skip to page content
USDA Forest Service
  
Treesearch

Research & Development Treesearch

 
Treesearch Home
About Treesearch
Contact Us
Research & Development
Forest Products Lab
International Institute of Tropical Forestry
Northern
Pacific Northwest
Pacific Southwest
Rocky Mountain
Southern Research Station
Help
 

Science.gov - We Participate


USA.gov  Government Made Easy


Global Forest Information Service

US Forest Service
P.O. Box 96090
Washington, D.C.
20090-6090

(202) 205-8333

You are here: Home / Search / Publication Information
Bookmark and Share

Publication Information

View PDF (2.22 MB bytes)

Title: Dowel-laminated crossties: performance in service, technology of fabrication, and future promise

Author: Howe, John P.; Koch, Peter;

Date: 1975

Source: Forest Products Journal, Vol. 26(5): 23-30

Publication Series: Miscellaneous Publication

Description: It is generally agreed that railroads of the United States must be substantially increase their rate of tie renewals, if roadbeds are to be maintained in acceptable condition. To accomodate faster trains and heavier loads, future mainline ties may average larger than the 7- by 9-inch size now in common use; fewer 6-by 8-inch ties will be utilized. A logical source of wood for these ties is the enormous inverntory of underutilized small hardwoods in the South, East, and Midwest. The process of dowel-lamination can permit manufacture of wane-free 7- by 9-inch mainline ties from logs with small-end diameters of only 8.3 inches- a size plentiful in this inventory. Bigger ties can easily be fabricated from logs only slightly larger. Through use of a new type of conversion machine - the shaping-lathe headrig-lumber recovery can approach 10 bd. ft/ft3 of log input, with six half-ties produced per minute. Mainline ties dowel-laminated from two half-ties (interface vertical when in place) have suffered no failures in extensive service tests extending over 15 years, and their service life should be at least as long as that usual for one-piece ties. Laboratory tests indicate that dowels withdrawn from dry wood have greater withdrawal resistance if they are inserted in gree (rather than dry) wood. When 1/2-inch fluted-steel dowels were inserted in green wood and withdraw from dry wood of four species, withdrawal forces were highest in hickory and blackgum (Average 1,935 lb./in. of penetration) and least in southern red oak and sweetgum (Average 1,468 lb./inch. of penetration). These findings are useful, because handling costs can be reduced if half-ties are doweled green rather than dry, as is the present practice. Six half-inch fluted-steel dowels per tie should be adequate.

Publication Notes:

  • We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
  • This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
  • You may send email to pubrequest@fs.fed.us to request a hard copy of this publication. (Please specify exactly which publication you are requesting and your mailing address.)

XML: View XML

Citation:


Howe, John P.; Koch, Peter 1975. Dowel-laminated crossties: performance in service, technology of fabrication, and future promise. Forest Products Journal, Vol. 26(5): 23-30

 


 [ Get Acrobat ]  Get the latest version of the Adobe Acrobat reader or Acrobat Reader for Windows with Search and Accessibility

USDA logo which links to the department's national site. Forest Service logo which links to the agency's national site.