Skip to page content
USDA Forest Service
  
Treesearch

Research & Development Treesearch

 
Treesearch Home
About Treesearch
Contact Us
Research & Development
Forest Products Lab
International Institute of Tropical Forestry
Northern
Pacific Northwest
Pacific Southwest
Rocky Mountain
Southern Research Station
Help
 

Science.gov - We Participate


USA.gov  Government Made Easy


Global Forest Information Service

US Forest Service
P.O. Box 96090
Washington, D.C.
20090-6090

(202) 205-8333

You are here: Home / Search / Publication Information
Bookmark and Share

Publication Information

View PDF (1.6 MB bytes)

Title: Timber rivet connections in US domestic species

Author: Begel, Marshall; Wolfe, Ronald W.; Stahl, Douglas C.;

Date: 2004

Source: Res. Pap. FPL-RP-619. Madison, WI: U.S. Department of Agriculture, Forest Service, Forest Products Laboratory, 2004. 15 pages

Publication Series: Research Paper (RP)

Description: This paper discusses results of tests conducted to expand the data base on the performance of timber rivet connections in U.S. domestic species to verify existing and proposed design procedures. Eight-, 80-, and 200-rivet connections were tested. The 8-rivet joint tests illustrate the effects of material type, rivet length, and load direction on the behavior of rivet connections when gross wood failures are avoided. The 80-rivet connections, loaded perpendicular to grain, show the effect of rivet spacing as well as test support conditions on failure mode and strength. The 200-rivet joints, with load applied parallel to grain, provide data for previously reported failure modes, including the rivet yield/wood crush modes modeled by European yield model (EYM) and gross wood failures. The 200-rivet tests also show the effect of rivet spacing on joint strength and failure mode. The tests were conducted in two phases. In Phase I, small specimens were made from Southern Pine and ponderosa pine solid sawn lumber, Hem–Fir and Southern Pine glulam, and parallel strand lumber. The small specimens failed by a combination of rivet yielding and wood crushing as described by EYM, rather than by a gross failure of the wood block. Joint yield load was determined by fitting test data to a curve and finding the load at 5% offset displacement. Basic trends can be seen in the data, but yield load is a poor predictor of ultimate load. In Phase II, large specimens were made from Southern Pine glulam. Larger rivet spacing, wider specimens, and longer rivets generally increased joint capacity; end spacing had no significant effect. Short continuously supported beams had a higher capacity load than did longer simply supported beams. The results show that when wood failure modes occur, thicker glulam has higher capacity, contradicting the size effect of the design code.

Keywords: Glulam rivet, timber rivet, connection, design model

Publication Notes:

  • We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
  • This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.

XML: View XML

Citation:


Begel, Marshall; Wolfe, Ronald W.; Stahl, Douglas C. 2004. Timber rivet connections in US domestic species. Res. Pap. FPL-RP-619. Madison, WI: U.S. Department of Agriculture, Forest Service, Forest Products Laboratory, 2004. 15 pages

 


 [ Get Acrobat ]  Get the latest version of the Adobe Acrobat reader or Acrobat Reader for Windows with Search and Accessibility

USDA logo which links to the department's national site. Forest Service logo which links to the agency's national site.