Skip to page content
USDA Forest Service
  
Treesearch

Research & Development Treesearch

 
Treesearch Home
About Treesearch
Contact Us
Research & Development
Forest Products Lab
International Institute of Tropical Forestry
Northern
Pacific Northwest
Pacific Southwest
Rocky Mountain
Southern Research Station
Help
 

Science.gov - We Participate


USA.gov  Government Made Easy


Global Forest Information Service

US Forest Service
P.O. Box 96090
Washington, D.C.
20090-6090

(202) 205-8333

You are here: Home / Search / Publication Information
Bookmark and Share

Publication Information

View PDF (211 KB bytes)

Title: Mechanisms responsible for the effect of wet bulb depression on heat sterilization of slash pine lumber

Author: Simpson, William T.;

Date: 2003

Source: Wood and fiber science. Vol. 35, no. 2 (2003): Pages 175-186

Publication Series: Miscellaneous Publication

Description: Heat sterilization is often required to prevent spread of insects and pathogens in wood products in international trade. Heat sterilization requires estimating the time necessary for the center of the wood configuration to reach the temperature required to kill insects or pathogens. In these experiments on 1.0- and 1.8-in.- (25- and 46-mm-) thick slash pine, heating time at 160°F(71°C) increased exponentially with increase in wet bulb depression. The time required for the center of green 1.0-in.- (25-mm-) thick boards to reach 133°F (56°C) vaned from 15 min at a low wet bulb depression near saturation to 438 min at the dry conditions of 50°F (27.8°C) wet bulb depression. For green 1.8-in.- (46-mm-) thick boards, the range was 38 to 198 min, and for air-dried 1.0-in.- (25-mm-) thick boards, the range was 9 to 23 min. When the wet bulb temperature in the kiln was below the desired target center temperature of 133°F (56°C), heating times were extended far beyond the times when it was not, which caused problems in attempts to estimate heating times. Surface temperatures during heating were found to decrease from evaporative cooling as wet bulb depression increased. A finite difference solution to the heat flow equations, solved for the boundary condition of a time-dependent change in surface temperature during heating, offers a good estimate of heating time when the wet bulb temperature of the heating air is above the desired target center temperature. An analysis was developed to estimate the surface transfer coefficient that describes this boundary condition.

Keywords: Heat sterilization, international trade, kiln-drying

Publication Notes:

  • We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
  • This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.

XML: View XML

Citation:


Simpson, William T. 2003. Mechanisms responsible for the effect of wet bulb depression on heat sterilization of slash pine lumber. Wood and fiber science. Vol. 35, no. 2 (2003): Pages 175-186

 


 [ Get Acrobat ]  Get the latest version of the Adobe Acrobat reader or Acrobat Reader for Windows with Search and Accessibility

USDA logo which links to the department's national site. Forest Service logo which links to the agency's national site.